Eppendorf Innova 43R Incubator Shakers - Manual (Page 23)

23
New Brunswick Operating manual
Clamps for 2-, 2.8-, 4- and 6-liter flasks are shipped with an additional girdle to keep the
flasks in place (see Figure 6). To install these double girdle clamps:
1. Place clamp on platform, secure in place with correct type of screws: #S2116-3051,
10-24 x 5/16-inch flat Phillips head, provided with the clamps (see Figure 6a).
2. Place the loose girdle around the upper portion of clamp body so that it is held in
place by the legs of the clamp.
3. Insert the flask into the clamp, and push the girdle down so the rubber tubes are in
contact with the platform and the flask.
Figure 6: Double Girdle Clamp Installation
1 Platform 4 Clamp body (legs & base)
2 Clamp mounting holes (5) 5 Lower girdle with girdle tubes
3 Upper girdle with girdle tubes
Figure 6a: Clamp Fastener

6.4 Electrical Connections
Before making electrical connections, verify that the power source voltage matches the
voltage on the electrical specification plate and that the
ON/OFF
switch is in the
OFF
position. The electrical specification plate is located on the rear panel of the shaker near
the power connector.
3
1
2
4
5