Eppendorf Innova 43R Incubator Shakers - Manual (Page 24)

24
Innova 43 & 43R Incubator Shakers  M1320-0050 Operating manual
Connect the power cord to the power connector, then connect the other end to a suitable,
grounded receptacle. Make sure there is enough clearance to disconnect the plug
whenever necessary.
Figure 7: Rear Panel
1 Power connector
2 Exhaust vents: do not block!!
3 Adjustable foot
6.5 Optional Gassing Manifold Kit
This option is factory-installed. The manifold delivers gas into the chamber via as
many as 12 ports (see Figures 8 & 9 on the following page). The manifold can be
adapted to the desired tubing configuration by adding or subtracting ports or by
temporarily clamping off unused tubes. You may elect to use splitters (barbed Y-
connectors) after the manifold to increase the number of flasks you can serve.
You determine the appropriate gas flow rate using a pressure regulator (which you
supply) on the gas supply.
NOTE:
Gas supply should be regulated and it must never exceed 15 PSIG.
50 feet of 1/16-inch (ID) sterilizable silicone tubing is supplied with the kit. Filters may
be needed: 0.22μ syringe filters (which you supply) can be fitted to the individual
manifold ports to maintain a sterile barrier.
1
3
2