Brady TLS 2200 User Manual
Page 90
82
TLS2200
T M
Thermal Transfer Printer User’s Guide
Connecting the TLS2200
TM
Printer to a PC
Complete the following steps to connect the TLS2200 printer to a PC:
1.
Locate the communication port on the bottom of your TLS2200 printer. This is the
port that looks similar to a modular phone jack and is found on the bottom of the
printer.
2.
Plug the communications cable into the communications port and set the TLS2200
printer next to your PC.
3.
Locate an unused serial port on the back of your PC. This port looks similar to the
diagram below.
Serial Port
Note: If you have a 25-pin serial port instead of a 9-pin port, you should
purchase an adapter from a computer parts supplier.
4.
Plug the free end of the communications cable into the serial port and tighten the
screws.
Communication
Port
On/Off Switch
Battery Pack