Brady TLS 2200 User Manual

Page 45

TLS2200

T M

Thermal Transfer Printer User’s Guide

Continuous Printing—Terminal Block Labels

This section discusses making terminal block labels with the TLS2200

printer.

Creating Terminal Block Labels

Terminal block labels can be created and printed using the TLS2200 printer. Simply choose
the appropriate center-to-center spacing repeat (pitch) for the block, enter your text, and
print as needed. The number of lines of text available at each termination is dependent on
repeat value spacing and the font size chosen.

Setting the Center-to-Center Spacing

The center-to-center spacing (terminal block repeat) is set by accessing the Term Repeat
option on the Setup Menu. Follow the instructions below to set this option:
1.

Press the + keys to access the Setup Menu.

Press the <

> key two times to scroll to the Continuous Menu, press the

key.

With the cursor on the Terminal Block option, press .

Use the arrow keys to adjust the terminal block repeat value, then press .

The repeat can be set from 2 mm (0.19685 in) to 46 mm (1.81102 in). Press the <

> and

> keys to increase/decrease the repeat value by 0.125 mm increments (1 dot). Press the

+ <

> and + <

> to increase/decrease the repeat value by 1 mm

increments (8 dots).

Note: Press after printing to advance the terminal strip label to the cut
position.