Brady TLS 2200 - Manual (Page 87)

TLS2200
T M
Thermal Transfer Printer User’s Guide 79
Appendix 3: Using the TLS2200

Program Installer
Use the TLS2200 Program Installer to install new software on your TLS2200 printer using
your personal computer. This installer uses a wizard interface to simplify the installation
process.
System Requirements
To use the TLS2200 Program Installer, you need a PC with the following:
•
Windows 95, 98, or NT4.0 or higher with Service Pack 3
•
16 M of RAM
•
10 M of hard drive space
•
One unused serial port
•
3.5” floppy drive (if installing from disk)
•
Internet connection (if installing from the Internet)
In addition, you need the communications cable that connects the TLS2200 printer to your
PC. This cable is available from Brady. See the Accessory Parts List on page 70.
Installing the TLS2200

Program Installer from the Internet
Note: The TLS2200 Program Installer is available either from the Brady Internet
website or on floppy disks. The installation procedure outlined below is for
individuals that have downloaded the installer from the Brady Internet website. Refer to the
section Installing the TLS2200
 Program Installer from Disk if you purchased the
Program Installer on disks.
Complete the following steps to install the Installer on your PC from the file available on
the Brady Internet website:
1.
Log on to the Brady website at www.tls2200.com.
2.
Go to the download area and click on the file you wish to download.
3. Select a folder on your hard drive in which to place the downloaded file and click OK.
It may take a few minutes to download the file from Brady, depending on the speed
of your PC’s modem.