Printing your labels – Brady TLS 2200 User Manual

Page 34

TLS2200

T M

Thermal Transfer Printer User’s Guide

Printing Your Labels

Adjusting Burn Temperature

The burn temperature setting can be adjusted to darken or lighten your printed legend.
Cases where adjustments are needed should be rare as the TLS2200

printer

automatically optimizes the burn temperature based on the material loaded in the unit.

Note: The burn temperature is automatically reset to its default setting of 0 each
time the unit is turned off. To obtain further information on adjusting the burn

temperature, refer to The Setup Menu section on page 13.

Setting Peel Time

After your label(s) are printed, the TLS2200 printer feeds the last printed label to the cut-
off position. If you wish to remove (peel) the last printed label from the liner without
cutting, the peel function can be used. Simply Press + on the keypad and
the unit advances the last printed label forward to the peel position. Depending on how the
default is set, you have from 2 to 9 seconds to peel the label from the liner before it returns
to the cut-off position. For more information on setting the peel time, refer to The Setup
Menu section on page 13.

Note: The peel time option is not supported for BradySleeve and PermaSleeve
label parts. After printing, BradySleeve advances to the tear-off position and

PermaSleeve advances to the cut position.

Printing Larger Labels

Die cut label formats greater than 1.9” x 2.0” will print with version 2 software or higher.
If you are using version 1 software, you will be able to print larger labels, but only up to
the printable area limits of 1.81” x 1.81”. Refer to Appendix 3: Using the TLS2200



Program Installer for help with installing new software on your TLS2200 printer.