Class1 FoamLogix 2.1A & 1.7AHP REV D - Manual (Page 76)

FoamLogix, Model 2.1A and 1.7AHP Class “A”
Electronic Foam Proportioning Systems
76
SECTION 7 ILLUSTRATED PARTS BREAKDOWN
GENERAL
This section contains drawings and the parts breakdown for the serviceable assemblies, compo nents and most
commonly used options for the FoamLogix, Model 2.1A Class “A” Electronic Foam Proportioning System.
ABBREVIATIONS
The following abbreviations may be used in this IPB:
A/R................. As required
Cm ................. Centimeters
Ext. ................ External
Fwd ................ Forward
Ga .................. Gauge
Grd, Gr ........... Grade – when hardware lists a grade rating, it is imperative to maintain that rating when
replacing parts.
HS ................. Hardened Steel
Hex ............... Hexagonal
Id, ID .............. Inner diameter
IPB ................. Illustrated Parts Breakdown
JIC ................. Joint Industry Conference – an industry standard used to describe a fitting.
Lh, LH ............ Left Hand
MM ................. Millimeters
Mtg ................ Mounting
n/s ................. Not Shown – parts that are not shown but are servicable.
No .................. Number
NPT .............. National Pipe thread
NPTF ............. National Pipe Thread, Fine
OD ................ Outer diameter
p/n ................. Part number
Ref ................. Reference
Rev ................ Reverse Rh
RH ................ Right hand
Str .................. Straight – usually to describe a hydraulic or pneumatic fitting (vs. elbow)