Class1 FoamLogix 2.1A & 1.7AHP REV D - Manual (Page 11)

FoamLogix, Model 2.1A and 1.7AHP Class “A”
Electronic Foam Proportioning Systems 11
SECTION
1
SAFETY
IMPORTANT!
THE HALE “FOAMLOGIX™” MODELS 2.1A
AND 1.7AHP CLASS “A” ELECTRONIC FOAM
PROPORTIONING SYSTEMS ARE DESIGNED
FOR OPTIMUM SAFETY OF ITS OPERATORS
AND TO PROVIDE RELI ABLE AND SAFE FOAM
CONCENTRATE INJEC TION. FOR ADDED
PROTECTION AND BEFORE ATTEMPTING
INSTALLATION OR OPERATION PLEASE FOLLOW
THE SAFETY GUIDELINES LISTED IN THIS SECTION
AND ADHERE TO ALL WARNING, DANGER, CAUTION
AND IMPORTANT NOTES FOUND WITHIN THIS
GUIDE.
THIS SECTION ON SAFETY MUST BE CARE FULLY
READ, UNDERSTOOD AND ADHERED TO STRICTLY
BY ALL INSTALLERS AND OPERA TORS BEFORE
ATTEMPTING TO INSTALL OR OPERATE THE
FOAMLOGIX PROPORTIONING SYSTEM.
WHEN DEVELOPING DEPARTMENTAL APPARA TUS
OPERATING PROCEDURES, INCORPORATE THE
WARNINGS AND CAUTIONS AS WRITTEN.
FoamLogix is a trademark of Hale Products,
Incorporated. All other brand and product
names are the trademarks of their respective
holders.
GUIDELINES
READ ALL INSTRUCTIONS THOROUGHLY BE FORE
BEGINNING ANY INSTALLATION OR OPERATION
PROCESS.
❑
Installation should be performed by a trained
and qualified installer, or your authorized Hale
Products service representative.
❑
Be sure the installer has sufficient knowledge,
experience and the proper tools before
attempting any installation.
❑
Make sure proper personal protective equipment
is used when operating or servicing apparatus.
❑
A foam tank low level sensor must be utilized
to protect the Hale Foam proportioner from dry
running. Failure to use a low level sensor with
the Hale Foam system voids warranty.
❑
DO NOT permanently remove or alter any
guard or insulating devices, or attempt to
operate the system when these guards are
removed.
Make sure all access/service panels and
covers are installed, closed and latched tight,
where applicable.
❑
DO NOT remove or alter any hydraulic or
pneumatic connections, electrical devices,
etc. DO NOT tamper with or disconnect safety
features or modify protective guards (such
as covers or doors). DO NOT add or remove
structural parts. Doing so voids the warranty.
Any of the above could affect system capacity
and/or safe operation of the system and is
a serious safety violation which could cause
personal injury, could weaken the construction
of the system or could affect safe operation of
the FoamLogix Proportioning System.
WARNING!
NO MODIFICATIONS OR ADDITIONS MAY BE MADE
TO THE FOAMLOGIX PORPORTIONING SYSTEM
WITHOUT PRIOR WRITTEN PERMIS SION FROM:
Hale Products, Incorporated
700 Spring Mill Avenue
Conshohocken, PA 19428
Telephone: 610-825-6300
Fax: 610-825-6440
❑
To prevent electrical shock always
disconnect the primary power source
before attempting to service any part of the
Hale Foam system.