Class1 FoamLogix 2.1A & 1.7AHP REV D - Manual (Page 17)

FoamLogix, Model 2.1A and 1.7AHP Class “A”
Electronic Foam Proportioning Systems 17
Package “B” includes dual check valve
manifold.
Note: If package “A” is selected an additional check valve
is required where the foam manifold attaches to the pump
discharge for NFPA compliance.
4. The Hale FoamLogix 2.1A and 1.7AHP may also
be ordered “a-la-carte” if one of the standard
packages does not meet end user require ments.
When ordering the system “a-la- carte” for a
complete system the Pump and motor assembly,
flow sensor, flow sensor cable, low tank sensor
and check valve injector fitting must be ordered
as a minimum.
Ordering the components as a complete system
allows Hale to configure and test the complete
order, to ensure a problem-free system.
5. Additional Hale components available to
enhance system operation and ease installation
include:
❑
Control Cable Extension
❑
Waterway Check Valves
❑
Manifolds
❑
Flanges
System components are shown in the following
heading “System Configuration,” begin ning on
page 20.
All components listed are engineered and tested
with Hale Foam systems to provide optimum system
performance. Using the information provided in this
manual and the detailed ordering procedures on
the option order form ensures that a complete Hale
Foam system is ordered thus eliminating delays
caused by missing components.