Xerox WorkCentre M20-M20i-2723 - Manual (Page 91)

Xerox WorkCentre M20i System Administration Guide Page 7-3
Network Installation
Us
in
g In
te
rn
et
Se
rvic
es
Using CentreWare Internet Services
Introduction
CentreWare Internet Services uses the embedded HTTP Server on the WorkCentre M20i to
allow communication with the WorkCentre M20i if you have a Web Browser with access to the
Internet or Intranet. By entering the IP Address of the WorkCentre M20i as the URL (Universal
Resource Locator) in the Browser, direct access to the WorkCentre M20i is available.
NOTE: Microsoft Internet Explorer version 4.x or later should be used. Other
browsers may work, but could produce unexpected results.
Many of the selections and settings needed to install WorkCentre M20i on a network can be
made using Internet Services, eliminating steps that would otherwise need to be performed at
the WorkCentre M20i Control Panel.
Many of the features available within Internet Services will require an admin user name and
password. A user will only be prompted for an admin name and password once in a single
browser session.
Before the Internet Services feature can be used for installing WorkCentre M20i on a network
it must be enabled. There are two stages required to enable Internet Services:
¾ Network Communication Setup
This requires the WorkCentre M20i to be setup for Internet Services.
¾ Enable Internet Services
¾ Make settings to the appropriate network
NOTE: When making more than one configuration change please complete all the
changes in one go and then carry out a reboot.