Xerox WorkCentre M20-M20i-2723 - Manual (Page 71)

Xerox WorkCentre M20i System Administration Guide Page 5-3
Ap
ple
T
alk
AppleTalk Installation
Installation Procedure
There are two stages required to install the WorkCentre M20i on an AppleTalk network:
¾ Network Communication Setup
This requires the WorkCentre M20i to be setup for AppleTalk.
¾ Print Driver Installation
¾ Test Print
A test print should be submitted to ensure the WorkCentre M20i has been
installed and configured correctly.
Network Communication Setup
This procedure is used to setup the network communication parameters of the WorkCentre
M20i.
At the WorkCentre M20i, perform these steps:
HINT: Xerox CentreWare Internet Services can also be used to configure the
WorkCentre M20i, refer to the Internet Services chapter for instructions.
¾ Connect the device to the network outlet or cable.
¾ Press the [Machine Status] button.
1
2
3
¾ Press or until System
Admin Tools is displayed and
press [Enter].
¾ If the System Admin Tools have
been passcode protected, type in
the password and press [Enter].
System Admin Tools
[Passcode Protect]