Xerox WorkCentre M20-M20i-2723 - Manual (Page 111)

Xerox WorkCentre M20i System Administration Guide Page 7-23
Network Installation
Us
in
g In
te
rn
et
Se
rvic
es
¾ Select the [Status] tab and then select [Reset Network Controller] to enable the
selections to take effect.
¾ Continue with Test Print.
Test Print
To ensure the device has been installed on the network correctly a test print should be
submitted from a client workstation. Perform the following steps:
¾ Open a document on a client workstation.
¾ Select the device as the printer to which the selected document will be sent.
¾ Print the document on the device and verify that it prints correctly.
¾ Make sure that the driver is installed on every workstation that will be sending jobs to the
device.
¾ Repeat the test for all workstations that will be sending jobs to the device.
¾ The installation process is now complete.
If the test print fails, refer to the Problem Solving chapter for trouble-shooting procedures.
6
7
1
2
3
4
5
6