Xerox WorkCentre M20-M20i-2723 - Manual (Page 120)

Page 8-4 Xerox WorkCentre M20i System Administration Guide
Lo
cal Co
nn
ectio
n Driver Installation
Before printing, scanning or using ControlCentre through the parallel port or the USB port
connected between the workstation and the
WorkCentre M20i, you will need to install a
driver.
The procedure will install the driver and configure it for the local port.
To install the driver on the workstation.
¾ Insert the Driver CD into the CD drive.
Within a few seconds, the CD should start automatically and present you with the opening
screen. If this does not happen, go to the Start menu, choose Run and browse to the CD
drive. Select Setup and click OK. Click OK to start the installation procedure and present
you with the opening screen.
¾ Choose the language for the installation and click [Continue].
1
2