Konica Minolta bizhub 500 - Manual (Page 88)

Administrator Operations 2
500/420 2-69
Ad
minist
ra
to
r Op
er
at
ions
Chapter 2
2.11.1 Setting the Overwrite All Data function
2
Note
When the main power switch is turned off, then on again, wait at least 10
seconds to turn it on after turning it off. if there is no wait period between
turning the main power switch off, then on again, the machine may not
function properly.
Here is the sequence, through which the main power switch and sub
power switch are turned on and off:
Turn off the sub power switch
→ Turn off the main power switch → Turn
on the main power switch → Turn on the sub power switch
Do not leave the machine with the Administrator Setting mode setting
screen left shown on the display. If it is absolutely necessary to leave the
machine, be sure first to log off from the Administrator Setting mode.
0 For the procedure to call the HDD Setting menu to the display, see steps
1 and 2 of “Setting the HDD Lock Password” on page 2-52.
1
Call the HDD Setting to the screen from the control panel.
2
Touch [Overwrite All Data].
420_security_E.book 69 ページ ２００７年３月７日 水曜日 午後３時１５分