Konica Minolta bizhub 500 - Manual (Page 192)

Application Software 4
500/420 4-37
Application Software
Chapter 4
7
Type the 8-digit Administrator Password registered in the machine in
the “Administrator Password” box.
8
Click the [Next].
? What happens if a wrong Administrator Password is entered?
% If a wrong Administrator Password is entered, a message appears
saying that there is a mismatch in the passwords and entry of the
Administrator Password will be prohibited for five sec. Wait for
some while before entering the correct Administrator Password.
% If the Enhanced Security mode is set to [ON], entry of a wrong pass-
word is counted as unauthorized access. If a wrong Administrator
Password is entered a predetermined number of times (once to
three times) set by the Administrator of the machine or more, a
message appears saying that the machine accepts no more Admin-
istrator Passwords because of unauthorized access for any subse-
quent entry of the Administrator Password. The machine is then set
into an access lock state. To cancel the access lock state, turn off,
and then turn on, the main power switch of the machine. When the
main power switch is turned off, then on again, wait at least 10 sec-
onds to turn it on after turning it off. If there is no wait period be-
tween turning the main power switch off, then on again, the
machine may not function properly.
Here is the sequence, through which the main power switch and
sub power switch are turned on and off:
Turn off the sub power switch
→ Turn off the main power switch →
Turn on the main power switch → Turn on the sub power switch
% The Encryption Key are subject to Restore. Make sure that the set-
tings when Backup is executed are not forgotten, since settings are
restored to those set during Backup after Restore.
9
Check the data that has been set and click [Start].
420_security_E.book 37 ページ ２００７年３月７日 水曜日 午後３時１５分