Konica Minolta bizhub 500 - Manual (Page 128)

User Operations 3
500/420 3-17
Use
r Op
er
at
ions
Chapter 3
8
Enter the 8-digit Secure Print Password from the keyboard and key-
pad.
– Press the [C] key to clear all characters.
– Touch [Delete] to delete the last character entered.
– Touch [Shift] to show the upper case/symbol screen.
– Touch [Cancel] to go back to the screen shown in step 7.
9
Touch [OK].
? What if there is a mismatch of the Secure Print Password relative to
the Secure Print ID?
% If there is a mismatch of the Secure Print Password relative to the
Secure Print ID, a message appears that tells that authentication
has not been successful. The machine then prohibits entry of the
Secure Print Password for 5 sec. Enter the correct Secure Print
Password.
% If two or more Secure Print Documents have been selected in step
7, the machine counts as unauthorized access any Secure Print
Document, the Secure Print Password of which is a mismatch.
% If the Enhanced Security mode is set to [ON], entry of a wrong Se-
cure Print Password is counted as unauthorized access. If a wrong
Secure Print Password is entered a predetermined number of times
(once to three times) set by the Administrator of the machine or
more, a message appears that tells that authentication has not
been successful for any subsequent operation for authentication.
The machine is then set into an access lock state, disabling access
to the Secure Print Document. To cancel the access lock state, the
Administrator of the machine must perform the Release Setting.
Contact the Administrator of the machine.
420_security_E.book 17 ページ ２００７年３月７日 水曜日 午後３時１５分