Konica Minolta bizhub 500 - Manual (Page 34)

Administrator Operations 2
500/420 2-15
Ad
minist
ra
to
r Op
er
at
ions
Chapter 2
2.3 Preventing Unauthorized Access
When access to the Administrator Setting mode by the Administrator of the
machine via the control panel is authenticated, the machine takes a count of
the number of unsuccessful accesses to the Administrator Setting mode,
User Authentication, SNMP authentication, Secure Print authentication, and
User Box authentication. It also enables setting of the operation of the Pro-
hibit Function When Auth. Error that prohibits the authentication operation.
Either [Mode 1] or [Mode 2] can be selected for Prohibit Function When Auth.
Error. The factory setting is [Mode 1]. If the Enhanced Security mode is set
to [ON], it is prohibited to change the setting from [Mode 2] (check count:
three times). It is nonetheless possible to change the check count to select
from among once, twice, or three times. For details of each mode, see the
table below.
2.3.1 Setting Prohibit Function When Auth. Error
2
Note
Do not leave the machine with the Administrator Setting mode setting
screen left shown on the display. If it is absolutely necessary to leave the
machine, be sure first to log off from the Administrator Setting mode.
0 For the procedure to call the Security Setting menu to the display, see
steps 1 and 2 of “Setting the Enhanced Security mode” on page 2-11.
1
Call the Security Setting to the screen from the control panel.
Mode Description
Mode 1 If authentication fails, the authentication operation (entry of the password)
is prohibited for 5 sec.
Mode 2 If authentication fails, the authentication operation (entry of the password)
is prohibited for 5 sec. The number of times, in which authentication fails,
is also counted and, when the failure count reaches a predetermined val-
ue, the authentication operation is prohibited and the machine is set into
an access lock state.
420_security_E.book 15 ページ ２００７年３月７日 水曜日 午後３時１５分