Konica Minolta bizhub PRESS C8000e - Manual (Page 168)

About the network setting (IC-601) Chapter 8: Application
8-18
• A message may appear depending on the setting change you made, informing you that
the change will be enabled after the sub power switch is turned off then on.
• About the details of settings, refer to “User’s Guide Main Body.”
4.
From [Auto Setting],
select [Enable] for the
protocol to use.
5.
Set [IP Address], [Sub-
net Mask], and [Default
Gateway].
6.
When you use IPv6 addresses, press [Next], then select
[Enable] for [IPv6 Setting].
7.
From [IPv6 Auto Setting], select [Enable] or [Disable].
• If [Enable] is selected:
Go to Step 9 • If [Disable] is selected:
Go to Step 8
8.
Enter [Global Address].
9.
Press [OK].
10.
Set the other settings as required.