Konica Minolta bizhub PRESS C8000e - Manual (Page 45)

IC-601 5-5
5.1 Windows 8/Server 2012 5
6
Click [Create a new port:], and then select the port type.
% To use the LPR/Port9100 protocol, select [Standard TCP/IP Port].
% To use the SMB connection, select [Local Port].
7
Click [Next].
8
Specify the IP address and port.
% To use the LPR/Port9100 protocol, select [TCP/IP Device], and then enter the IP address.
% To use the SMB connection, enter [\\NetBIOS name\print service name] in the "Port Name" box.
% Enter the same NetBIOS name and print service name specified in [SMB Setting] - [Print Setting].
9
Click [Next].
% If [Additional Port Information Required] or [More Port Information Required] dialog box appears, go
to Step 11.
% If the [Install the printer driver] dialog box appears, go to Step 14.
10
Select [Custom], and then click [Settings...].
11
Change the settings according to the port, and then click [OK].
% For LPR connection, select [LPR], and then enter "Print" in the [Queue Name:] box.
% You must discriminate between upper and lower case letters when entering it.
% For Port9100, select [Raw], and then enter a RAW port number (initial setting: [9100]) in the [Port
Number:] box.
% If both LPR and Port 9100 are enabled on this machine, the printer driver is connected to this ma-
chine using LPR.
12
Click [Next].
The [Install the printer driver] page appears.
13
Click [Have Disk...].
14
Click [Browse...].
15
Select a desired printer driver in the CD-ROM, and then click [Open].
% Available printer drivers:
PS Plug-in driver, PPD driver, PCL driver
16
Click [OK].
17
Click [Next].
18
Follow the instructions on the pages that follow.
% If the [User Account Control] window appears, click [Continue] or [Yes].
19
Click [Finish].