RADWAG MA 200.3Y Moisture Analyzer - Manual (Page 65)

- 65 -
the software on printout).
Each non-standard printout is a separate project, featuring specific name,
by which it is identified, and saved in the database of printouts.
PROCEDURE:
1. Press option
2. Press key
3. A window is opened with the following data: Name/Code/Project
4. Set name and code of a printout
5. Press key
6. A keyboard is opened on the display for editing the printout
7. Use keyboard to design printout template, the printout may contain
texts and variables.
Caution:

User can add a printout by importing configured texts from data storage devices
connected to moisture analyzer’s USB port.

Printout’s name is ONLY a NAME, and it is not part of its content.

Means of designing a non-standard printout template is described in point 19.10
of this user manual
16.6. Profiles
Profiles are described in point 15. of this user manual.
17. DRYING PROCESS – GENERAL INFORMATION
Working mode <
Drying> is dedicated to determining moisture content in
a substance by its drying. On process start controlled by a user, the moisture
analyzer checks loss of mass of a substance placed in the drying chamber. The
substance sample is heated by a moisture analyzer, and on basis of mass
decrement, the software calculates moisture content in a sample, and visualizes
measurement result on the display. The drying result is continuously updated
during drying process course, and the process is completed automatically on
meeting finish mode requirements set by a user.
17.1. SAMPLE PREPARATION FOR DRYING
This section of the MA 3Y user manual contains data on setting optimum test
results during drying processes. There are hints for selection of appropriate
drying parameters for various materials and substances.