Pulsafeeder Pulsar DLC XP RC User Manual
Page 64

60
8. Orient the DLC-XP properly at a comfortable height above the pump and align the slot in the DLC-
XP coupling with the 'flats' on the adjustment shaft. You may have to turn the adjustment shaft. If
necessary, only turn the adjustment shaft in the counter clockwise direction.
9. Lower the DLC-XP onto the eccentric. It may be necessary to tip the DLC-XP slightly towards the
motor to clear the Motor adapter. With the DLC-XP approximately 25mm inch (1 inch) above the
eccentric box, make a fine adjustment to align the slot in the DLC-XP coupling with the adjustment
shaft 'flats.' Once aligned, lower the DLC-XP to mate with the eccentric box. Do not force the cover!
When the coupling is properly aligned, the DLC-XP will slide home under its own weight.
10. Install the 4 DLC-XP mounting screws and washers provided. Remove the 13 top DLC-XP top
cover.
11. Follow the instructions in Section 5-Installation: Electrical Wiring for electrical connections.
12. Perform the steps detailed in Section 6-Start-up.
13. Review the section 7-General Operation for detailed information on configuring your DLC and its
advanced features.