Pulsafeeder Pulsar DLC XP RC - Manual (Page 41)

37
5. The display will then prompt for the motor status when the Level Switch input trips:
LEVEL SWITCH
MOTOR OFF? NO
Press [ENTER] if you DO NOT want the PULSAR motor to turn off when the input is sensed. Go to
step 7.
6. If you do want to the PULSAR motor to shut off is a low level is sensed, press [UP] to scroll to
{YES}. Press [ENTER].
LEVEL SWITCH
MOTOR OFF? YES
7. The display prompts you for the alarm relay status should Level Switch input trigger.
LEVEL SWITCH
ALARM RELAY? NO
Press [ENTER] if you do not want the Alarm Relay to activate with the Level Switch input. Go to
step 9.
8. If you want the Alarm Relay to activate with the Level Switch input, press the [UP] arrow key to
scroll to {YES}. Press [ENTER] to accept the setting.
LEVEL SWITCH
ALARM RELAY? YES
9. The display returns to the {MENU / DRUM LEVEL} screen.
7.2.6 Digital Output Set Up
This sub-menu is not functional with the NEMA 7 option.
7.2.7 Motor Thermostat Set Up
This sub-menu is not functional with the NEMA 7 option.
7.2.8 Over Temperature Set Up
This sub-menu allows you to disable the warning message when the DLC’s internal temperature
approaches it’s operating limit of 70
°C / 158°F. The error condition will not reset until the
temperature drops below 65
°C / 149°F. The difference between the trip and release point is 5°C /
9
°F.
1. Press [MENU] once and then [UP] seven (7) times until the display reads {– MENU – / OVER
TEMPERATURE}.
– MENU –
OVER TEMPERATURE
Press [ENTER] to go to the Over Temperature sub-menu.
2. The {OVER TEMPERATURE / ENABLED} (system default) screen is displayed.
OVER TEMPERATURE
ENABLED
3. Press [ENTER} to accept the {ENABLED} setting and you are returned to the {– MENU – / OVER
TEMPERATURE} screen.
or
Press [UP] to display the {OVER TEMPERATURE / DISABLED} screen.
OVER TEMPERATURE
DISABLED