Pulsafeeder Pulsar DLC XP RC - Manual (Page 11)

7
5.3 Getting Started
The field wiring terminals of the DLC-XP are accessed by removing the its cover. Remove the 13
retaining screws (Phillips head screw driver required). Refer to Figure 2. The field wiring terminals of
the DLC-RC are openly visible on the chassis.
Figure 2 – Accessing the Field Wiring board
The DLC-XP cover has the Serial Number Tag on it. Please keep the cover with the DLC-XP
from which it was removed. The DLC-XP is marked internally with the Serial Number. The
internal marking will be used for warranty claims.
The DLC-XP and DLC-RC Field Wiring Boards (see Figure 3) contains wiring blocks for making all of
the electrical connections.
Keep careful track of the hardware and o-ring used to secure and seal the upper cover of the control unit.
The upper enclosure cover of the DLC-XP pump-mounted control unit must be securely and properly
fastened to ensure compliance with hazardous area regulations. See Section 6.1.2 for the proper
procedure.