Pulsafeeder Pulsar DLC XP RC - Manual (Page 55)

51
10. Factory Default Values
CALIBRATION
Pump Flow 1-Point Calibration on PULSAR at Rated Flow and Pressure.
Analog Input 4 - 20mA
Analog Output 4 - 20mA
ANALOG INPUT
Failure Mode Freeze at last signal / Restore to Analog Mode
Operating Mode Active
LEAK DETECTION
Inactive
LEVEL SWITCH Inactive
POWER FAILURE
Motor Off
ALARM RELAY Normally Open
SECURITY
Type Off
DECIMAL FORMAT
Format 9,999.99
Position
Set at factory. PULSAR dependent (e.g., 9.9999, 0.99999, etc.)
LANGUAGE English
UNITS
Percent (%)
BATCH
Inactive
Batch #n Rate 0%
Batch #n Duration 0 H 00 M
Batch #n Type One Time Only
DATE/TIME
Date Format MM/DD/YY
Time Format 24:00
Daylight Savings No
Day of Week Sunday
VOLTAGE
Operating Set at Factory to Customer Requirement