beautypg.com

Pulsafeeder Pulsar DLC XP RC User Manual

Page 36

background image

32

You can access a sub-menu from the above screen by pressing [ENTER] if a circuit failure has
occurred. The lower level menus show more descriptive circuit information. The DLC – XP
performs a self-test at power-up. The values in the menus shown below are updated during
power-up. Use [UP] to scroll between sub-menus.

CIRCUIT FAILURE

RAM: OK

or

CIRCUIT FAILURE

RAM: FAIL

CIRCUIT FAILURE

EEPROM: OK

or

CIRCUIT FAILURE

EEPROM: FAIL

CIRCUIT FAILURE

MOTOR: OK

or

CIRCUIT FAILURE

MOTOR: FAIL

j) Use [UP] to scroll to the next sub-menu. The total pump operating time is displayed in this

diagnostic sub-menu. If a failure is detected in one of the other diagnostic sub-menus, by
pressing [ENTER] the user is prompted to reset the total run time or continue counting the total
operating hours.

DIAG MENU 10/11

RUN :XXX HRS

Press
[ENTER]

RESET RUN TIME

YES

k) Use [UP] to scroll to the next sub-menu. The NEMA 7 version of the DLC (XP/RC) does not

have a tachometer for a stroke counting capability.

DIAG MENU 11/11

STROKES: N/A

3. Pressing [ENTER] on the screens depicted in steps a, b, c, d, e, and g above will display the time and

date of the failure or more descriptive information.

POWER FAILURE

13:27 4/26/00

4. Press [ENTER] again, and the user is prompted to clear the failure. Depending upon the type of

failure diagnosed, the user may want to take other steps before clearing the failure and restarting the
pump. If so, press [ENTER] to keep the error date and time stamp. Otherwise, use [UP] to scroll to
"YES" and press [ENTER]. The DLC – XP will return to a normal condition.

POWER FAILURE
CLEAR? NO


If more than one failure occurred, repeat steps 3 and 4 above for each sub-menu that indicates a
failure was detected.