Pulsafeeder Pulsar DLC XP RC - Manual (Page 22)

18
6.1.1 User Interface Familiarization.
There are four key elements that will be useful in starting-up the DLC: the Display, the Keypad, the
DLC-XP and the Pump Motor. Refer to Figure 12 to familiarize yourself with the location of these
items before proceeding.
Figure 13 – Keypad
6.1.1.1 Display
This is a 2 line by 16 character alpha-numeric Liquid Crystal Display (LCD) located above the
keypad. It is back-lit with a yellow-green light source for easy viewing in dark areas. Its contrast can
be adjusted by using the keypad.
6.1.1.2 Keypad
The Keypad is a sealed 9-button membrane style input device. It is easy to use and will guide you
quickly to specific functions. Please take a few moments to familiarize yourself with the function of
each key before starting (also, see Figure 13):
Press this key to Start the PULSAR motor or place it in stand-by.
Press this key to access the Configuration Menu. Press the ARROW keys to
scroll through the Configuration Menu Items. Press MENU a second time to exit
the Configuration menu to the current operating status mode (e.g., MANUAL
MODE).
Press this key to cycle to the next unit type whenever a unit is displayed at the
operating status mode (e.g., MANUAL MODE).
These keys are used to change values currently displayed on screen. Use the
[DOWN] arrow to decrease the value and the [UP] arrow to increase it. Pressing
both [UP] and [DOWN] arrows simultaneously performs special editing and by-
pass functions. This is described further in the section 6-General Operation.
Use this key to accept a flashing value or parameter and proceed to the next sub-
menu screen.