Pulsafeeder MPC Vector - Manual (Page 5)

v
Conventions
For the remainder of this bulletin, the following Conventions are in effect.
A WARNING DEFINES A CONDITION THAT COULD CAUSE DAMAGE TO BOTH
THE EQUIPMENT AND THE PERSONNEL OPERATING IT . P AY CLOSE
ATTENTION TO ANY WARNING .
Notes are general information meant to make operating the equipment easier.
Revision History:
2-2006 Rev A First Release
3-2006 Rev B New menu maps
Digital I/O features added
4-2006 Rev C Add “Speed Mode Flow Cal” instructions
Misc. minor updates and changes for spelling, grammar, etc
7-2006 Rev D, E New illustrations, new dimensional diagram, change to MPC Vector name, added
model string, minor text revision, added 3 phase information for low Hp motors.
5-2007 Rev F Updated signal connections diagram
Added hand-held wiring diagram
Added PID tutorial information in appendix
Added startup and parameter setup information section 6
9-2007 Rev G Added notes and diagram for digital outputs, section 5.3.4 and 7.4
Corrected steps in Dry Flow Cal for Speed Control section
Other minor text changes and additions
1-2008 Rev H Update to match new software revision, multiple changes (3.01)
3-2008 Rev J Further updates and corrections for new software version (3.01)
Safety Considerations:
1. Read and understand all related instructions and documentation before attempting to install or
maintain this equipment
2. Observe all special instructions, notes, and cautions.
3. Act with care and exercise good common sense and judgment during all installation, adjustment, and
maintenance procedures.
4. Ensure that all safety and work procedures and standards that are applicable to your company and
facility are followed during the installation, maintenance, and operation of this equipment.