Pulsafeeder MPC Vector - Manual (Page 42)

36
9. Flow Meter Input
The MPC VECTOR accepts flow meter process feedback from an analog (4-20mA) flow metering device. The
manufacturer of the flow meter is not important but the process signal must conform to a set of minimum
specifications in order to work with the MPC VECTOR.
9.1 Flow Meter Installation
Prior to installation make sure your flow meter conforms to the MPC VECTOR’s flow meter specifications
(refer to Section 13, Specifications). Your flow meter must also be calibrated independently prior to
installation.
Figure 5 – Flow Meter Connection
1. Remove MPC VECTOR power and wait 30 seconds for complete power dissipation.
2. Connect your flow meter input to the Flow Meter Input Terminal Block (ref Fig. X.XX).
3. Plug in MPC VECTOR. After the system information is displayed the starting display will be:
S E T P T X X . X X X
F L O W X X . X X X
4. Press the MENU key
- M E N U -
C A L I B R A T I O N
5. Press the UP arrow key
- M E N U -
S Y S T E M S E T U P