Pulsafeeder MPC Vector - Manual (Page 11)

5
5. Installation and Wiring
5.1 Location
Review the Safety section (Section 2) prior to installing the MPC VECTOR. It contains information
required to properly install and operate the MPC VECTOR in an industrial environment.
The site selected for the installation of your MPC VECTOR is largely dependent on that of the gear pump.
Review the Installation, Operation, and Maintenance manual provided with your gear pump. It details
system related issues that are important to proper operation of the pump. Consider the following MPC
VECTOR related issues when selecting a site. Avoid locations where the MPC VECTOR would be
subjected to extreme cold or heat. Note the warning statement on the next page. The installation of this
device must comply with national, state and local codes.
The MPC VECTOR controller must be secured to an appropriate support before use. Use appropriate
hardware to secure the MPC VECTOR controller and pump to a smooth vertical surface. No assembly is
required for the MPC VECTOR controller itself.
Figure 1 – Typical Installation .
A VOID LOCATIONS WHERE THE MPC VECTOR WOULD BE SUBJECTED TO EXTREME COLD OR
HEAT [ LESS THAN 0°°°° C ELSIUS (32°°°° F AHRENHEIT ) OR GREATER THAN 40 °°°° C ELSIUS (104 °°°°
F AHRENHEIT )] OR DIRECT SUNLIGHT . F AILURE TO OBSERVE THIS WARNING COULD DAMAGE THE
MPC VECTOR AND VOID ITS WARRANTY .
AC POWER IN
AC TO MOTOR