Pulsafeeder MPC Vector - Manual (Page 22)

16
6.7 Flow Display
The MPC VECTOR will display calibrated pump flow in GPH, LPH, GPM, or LPM on the digital display
when configured for flow control. The motor speed (in RPM) may also be viewed while in flow control.
Changes to the flow units are made in the System Setup Menu.
6.8 Wrapping up
Your MPC VECTOR is now commissioned for use. Note that you cannot configure the software in a way
that would damage the MPC VECTOR. Typically, whenever you are about to set a critical value (e.g.,
Calibrate Flow), you are always prompted to confirm your change before it takes effect. If you are ever
dissatisfied with the configuration of your MPC VECTOR, you can always return to the Factory Defaults by
referring to Section 6.7.