Pulsafeeder MPC Vector - Manual (Page 21)

15
Setting Max Flow
1) Begin at the main screen displaying the current flow/speed setpoint
S E T P T 0 . 0 0 G P M
F L O W 0 . 0 0 G P M
2) Press the MENU key to access the menus.
- M E N U -
C A L I B R A T I O N
3) Press the UP or DOWN arrow keys until you get to System Setup.
- M E N U -
S Y S T E M S E T U P
4) Press the ENTER key to access System Setup Menus.
S Y S T E M S E T U P
S T A T U S
5) Press the UP key until you see the Information setup option.
S Y S T E M S E T U P
I N F O R M A T I O N
6) Press the ENTER key to access the Information screens.
P U L S A F E E D E R , I N C
F W : 1 . 0 4 / 1 . 0 4
7) P ress the UP or DOWN arrow keys until you see Max flow and Speed displayed.
M A X : 6 . 0 0 G P M
M A X : 1 8 0 0 R P M
8) Press the Enter key to allow Max Flow to be edited. A blinking cursor will appear
M A X : 6 . 0 0 G P M
M A X : 1 8 0 0 R P M
9) Press the UP or DOWN arrow keys to manipulate the flow rate until you reach your max flow.
M A X : 8 . 5 0 G P M
M A X : 1 8 0 0 R P M
10) P ress the ENTER key to accept the new Max Flow rate. Note that the blinking cursor has moved to the
Max Speed location.
M A X : 8 . 5 0 G P M
M A X : 1 8 0 0 R P M
11) Press the ENTER key again to save the Max Flow and Max Speed. Note that the blinking cursor
should disappear at this point.
M A X : 8 . 5 0 G P M
M A X : 1 8 0 0 R P M