Pulsafeeder MPC Vector - Manual (Page 44)

38
10. Motor Parameter Setup and Tuning
The MPC VECTOR controller must know several motor characteristics before the motor can be calibrated.
This calibration allows the controller to maintain precise control over the operation of the motor.
If the drive has not been calibrated an error will appear on the screen. In addition, at startup the User Interface
will be redirected to the Calibration/Motor Parameter sub-menu.
If your MPC VECTOR unit has been shipped from the factory as a complete unit with Eclipse pump
and motor, these parameters will have been entered at the factory. No further user input will be
required.
Note that the ranges listed in the table below reflect absolute min/max accepted by the drive and may not
match a specific application. These do not have to be set in any particular order but will be presented
sequentially by the User Interface. The parameters will need to be entered in the field if the MPC VECTOR
controller was shipped without a motor, or if the motor is changed to a different model than was originally
supplied.
S
ETTING THESE PARAMETERS IMPROPERLY AND RUNNING THE AUTO - CALIBRATION ROUTINE CAN
RESULT IN DRIVE ERRORS .
Reference motor parameter table, next page