Pulsafeeder MPC Vector - Manual (Page 19)

13
6.3 Keypad/Lamp Operation
Key Function Description
Motor On/Off Press to start pump, press again to stop pump
Auto/Manual
Press to toggle between automatic operation and manual
control of the pump
Menu
Press to adjust controller settings, to exit the menu system,
to move cursor back when entering values, or to step back to
higher level menus
Enter
Press to accept changes in menus, to move cursor forwards
when entering values, and to access lower level menus.
Arrow Up
Press to adjust values upwards, and to scroll through menu
options
Arrow Down
Press to adjust values downwards, and to scroll through
menu options
Lamp Color Description
Green, Amber,
Red, Off
Off = Motor off Green = Motor on
Amber = Remote standby Red (blinking) = Error
Green, Off Green = Manual Control Off = Automatic Control
Table 3 – Keypad and Lamp Operation
6.4 Confirm Display and Keypad Functionality
The example display messages are shown in English for demonstration purposes. If an alternate
language has been set, the text is displayed as a translation of the English version.
Now that you have confirmed that the MPC VECTOR is receiving power, it is necessary to confirm that the
display and keypad are functioning properly. On normal power-up, the display appears for approximately 2
seconds.
P U L S A F E E D E R I N C .
F W : 0 0 . 0 0 / 0 0 . 0 0
The first four digits displayed are the software revision for the MPC VECTOR control board, and the second
four indicate the software revision for the remote board.
MANUAL
ON