Pulsafeeder MPC Vector - Manual (Page 37)

31
7. Press the ENTER key to complete the PulsaGuard Calibration.
P U L S A G U A R D
C A L I B R A T E D
8.4.2 PulsaGuard Calibrations, no Flow Meter Feedback
PulsaGuard may be calibrated WET or DRY. A WET calibration requires that the user simulate
underloaded conditions.
Follow Steps 1-4 above. You should see the following screen
C A L I B R A T I O N
P U L S A G U A R D
5. Press the ENTER key.
P U L S A G U A R D
W E T C A L
WET CALIBRATION:
6. Press the ENTER key again to access the WET calibration routine.
S T A R T M O T O R
Y E S = E N T R N O = M E N U
7. Run the pump to meet desired low setpoint conditions. You may adjust the speed of the motor using
the UP and DOWN arrow keys. The output current of the motor will be displayed on the screen. The
values below are not indicative of what your display will show.
M I N S E T P T 2 . 0 A
S P E E D : 1 2 0 0 R P M
8. Once the MPC MPC VECTOR has reached the desired low current setpoint, press the ENTER key.
P U L S A G U A R D
C A L I B R A T E D
9. PulsaGuard Pump Protection is now calibrated and enabled.
DRY CALIBRATION:
6. Press the UP key
P U L S A G U A R D
D R Y C A L