Avaya CPSEE_TSP500 - Manual (Page 85)

Chapter 5 Admin Terminal Commands
CPSEE_TSP500 User Guide Version 4.0 Page 5-15
This document is confidential and proprietary to SER Solutions and is not for external use.
Table 5-6: Option Flags.
Option Description
Allow Dial Tone
To Stations 1 = Provide dial tone to stations.
0 – Don’t provide dial tone to stations.
Allow Manual
Dialing 1 = Allow Manual Dialing.
0 = Inhibit Manual Dialing.
Process SITs
via D Channel Specifies that extended call status provided in the ISDN PROGRESSING
message is used to classify the call.
1=Analyze the call using extended call status information.
0=Analyze the call using in-band SIT tone detection.
Perform Zapper
Detection 1 = Analyze for Zapper devices. – if a SIT is detected and answer supervision
is received, the SIT will be ignored and the call will continue to be analyzed for
Live voice or Answering Machine.
0 = Don’t analyze for Zappers. – If a SIT is detected regardless of supervision,
it will be classified as the appropriate SIT.
Monitor Key-
Use Pound Sign
- #123# This flag only applicable if the “install” flag MONITOR_KEY is turned ON (in
the install flags). It allow choosing the asterisk or pound sign to be used in the
key.
1 = Use #123# as the key.
0 = Use \*123\* as the key.
Allow Caller ID
Name Specifies that the Caller ID’s Name can be sent.
1 = Allow sending Caller ID text.
0 = Don’t send Caller ID Text.
Note: This flag is used as a global prevention method. It should not be turned
ON unless the carrier is willing to accept the Caller ID Text. Otherwise, dials
may fail.
Ignore Cadence
Break 1 = Ignore cadence breaks during Voice Detection.
0 = Consider a break in ring cadence to be an answered call.
This flag is normally turned ON.
Support New
Legislation
Events Specifies whether events used to comply with FTC regulations will be sent to
the adjunct.
1 = Send FTC events to the adjunct.
0 = Don’t send FTC events.
Dont Route
Inbound For Engineering Testing Only!
Always Beep
Agent on Con-
nect Specifies that an agent will be beeped prior to being connected to a call.
1 = Beep agent prior to connecting call.
0 = Do not beep agent prior to connecting call.
Note:
#123# is typically used when voice only monitors are used in a con-
ference supplied by a telco conferencing service (i.e. AT&T Confer-
encing Service) where the use of * will pull in operator assistance.