Avaya CPSEE_TSP500 - Manual (Page 107)

Chapter 5 Admin Terminal Commands
CPSEE_TSP500 User Guide Version 4.0 Page 5-37
This document is confidential and proprietary to SER Solutions and is not for external use.
At the end for each line may appear a R_LOOP or L_LOOP if the span is in
some form of loopback mode.
SPAN
This command is used to control the state of ISDN channels. Currently
unavailable because features of this command are not fully supported by the
TSP’s board venter (NMS).
Table 5-24: SLOTS Command
Command Description
Sl Slot (Span) Number. An "*" indicates this span is
the Clock Master.
Type T = Trunk D = Digital Station.
For ISDN lines another ‘D” next to the ‘T’ or ’D’
indicates the D channel is down.
Example:
T Trunk (if ISDN, D-Channel is UP)
D Digital Station (if ISDN, D-Channel is UP)
TD Trunk – D-Channel is DOWN.
DD Digital Station – D-Channel is DOWN
Protocol Network protocol loaded into the firmware.
Trunks Trunk Numbers associated with this span.
Alarm Displays current Alarms R = RED, Y = YELLOW, B
= BLUE, L = Loss of Signal.
RD Historic count of RED alarms.
BL Historic count of BLUE alarms.
YL Historic count of YELLOW alarms.
SL Count of slips.
TO Count of timeouts that occurred on this span.
EC Count of times error detection threshold was
exceeded.
NA Not applicable at this time.
BPV Count of Bipolar Violations.
LSY Count of Loss of Synchronization.
FE Count of Framing Errors.
LOS Count of Loss of Signal indications.