Connecting to a remote system, Menu, Select quit when you are done – Allied Telesis AT-S20 User Manual
Page 33: Connecting to a remote system -3, 4, connecting to a remote system, Rqqhfwlqj#wr#d#5hprwh#6\vwhp
AT-S20 User’s Guide
4-3
&RQQHFWLQJ#WR#D#5HPRWH#6\VWHP
0HQX1#
Administration> Connect to a remote system
This option allows you to use a AT-3726XL, AT-3726, AT-3716XL or
AT-3714FXL, AT-3714F switch to connect to and manage another
Allied Telesyn device. You can also use Telnet.
Select
Administration>
Connect to a remote system.
3. Enter one of the following:
system name
or
DNS name
if any,
IP address
, or
MAC address
.
Once the information is validated and the connection to the
remote switch is open, you immediately get the Omega
menus. You may then use the Omega menus to configure the
remote switch or run diagnostics.
The only option that is not available is
Connect to a
remote system
from the
Administration
menu (the
same is true if you used Telnet).
4. Select
Quit
when you are done.
Note
It is important that you select
Quit
after the Omega session.
Otherwise, you may block other sessions or software downloads via
the network to the remote switch. See also Setting Time Out
Protection on page 4-21.
Please specify the system to connect to:
The system may be identified by name (‘name’),
by IP address (128.2.3.4), or by Ethernet
address (0000F4 123456)
->_