Allied Telesis AT-S39 - Manual (Page 83)

AT-S39 Command Line Interface User’s Guide
83
DELETE SWITCH TRUNK
Syntax
delete switch trunk=name port=ports
Parameters
trunk Specifies the name of the trunk to be modified. (You
can enter any alphanumeric character for the name
and this command will work. This is useful if you
have forgotten the name you assigned the trunk.)
port Specifies the port to be removed from the existing
port trunk. You can remove more than one port at a
time. The ports can be specified individually (e.g.,
1,4) or as a range (e.g.,1-2).
Description
This command removes ports from an existing port trunk. To view the
ports of a trunk, refer to the SHOW SWITCH TRUNK command. To
completely remove a port trunk from a switch, see the DESTROY TRUNK
command.
Caution
Disconnect all data cables from the ports of the trunk on the switch
before using this command. Removing a port from a port trunk
without first disconnecting the cables may result in loops in your
network topology, which can produce broadcast storms and poor
network performance.
Example
The following command removes Port 9 from the port trunk:
delete switch trunk=a port=9