Allied Telesis AT-S39 - Manual (Page 164)

Chapter 18: 802.1x Port-based Access Control Commands
164
uniquely identified by the
switch by using the client's
MAC address. This is the
default setting.
forceauthenticate Disables 802.1X port-based
authentication and causes
the port to transition to the
authorized state without any
authentication exchange
required. The port transmits
and receives normal traffic
without 802.1X-based
authentication of the client.
The parameters are
equivalent.
forceunauthenticate Causes the port to remain in
the unauthorized state,
ignoring all attempts by the
client to authenticate. The
switch cannot provide
authentication services to
the client through the
interface. The parameters
are equivalent.
quietperiod Sets the number of seconds that the switch remains in
the quiet state following a failed authentication
exchange with the clien
t. The default value is 60
seconds. The range is 0 to 65,535 seconds.
txperiod Sets the number of seconds that the switch waits for a
response to an EAP-request/identity frame from the
client before retransmitting the request. The default
value is 30 seconds. The range is 1 to 65,535 seconds.
reauthperiod Enables periodic reauthentication of the client, which
is disabled by default. The default value is 3600
seconds. The range is 1 to 65,535 seconds.
supptimeout Sets the switch-to-client retransmission time for the
EAP-request frame. The default value for this
parameter is 30 seconds. The range is 1 to 600
seconds.