Allied Telesis AT-S39 - Manual (Page 75)

AT-S39 Command Line Interface User’s Guide
75
SET SWITCH SECURITYMODE
Syntax
set switch securitymode=automatic|limited|secure|
locked
Parameter
securitymode Specifies the switch’s security mode. Values are:
automatic Disables port security on the switch.
This is the default setting.
limited Sets the switch to the Limited security
mode. This mode allows you to specify
a maximum number of MAC addresses
each port can learn. To specify a MAC
address limit for a port, use the SET
SWITCH THRESHOLD command.
secure Sets the switch to the Secure security
mode. In this mode the switch forwards
frames based only on static MAC
addresses. After activating this security
mode, you must enter the static MAC
addresses of the nodes with frames the
switch is to forward. To add static MAC
addresses, use the ADD SWITCH FDB
command.
locked Sets the switch to the Lock All Ports
security mode. This mode causes the
switch to stop learning new dynamic
MAC addresses. The switch forwards
frames based on static MAC addresses
and on those dynamic addresses it has
already learned.
Description
This command sets a switch’s port security mode. Only one mode can be
active on a switch at a time. To view a switch’s current security mode
setting, use the SHOW SWITCH command.