Allied Telesis AT-S39 - Manual (Page 70)

Chapter 7: Port Parameter Commands
70
parameter settings are not changed by this
command. This parameter performs the same
function as the RESET SWITCH PORT command.
speed Sets the speed and duplex mode of the port. Setting
for this parameter are:
autonegotiate The port Auto-Negotiates both
speed and duplex mode.This is the
default setting.
10mfull 10 Mbps and full-duplex mode.
10mhauto 10 Mbps and half-duplex mode with
autonegotiation.
10mfauto 10 Mbps and full-duplex mode with
autonegotiation.
100mhalf 100 Mbps and half-duplex mode.
100mfull 100 Mbps and full-duplex mode.
100mhauto 100 Mbps and half-duplex mode
with autonegotiation.
100mfauto 100 Mbps and full-duplex mode
with autonegotiation.
1000mfull 1000 Mbps and full-duplex mode.
1000mfauto 1000 Mbps and full-duplex mode
with autonegotiation.
auto10m100m This setting is applicable only to the
AT-A46 expansion module. It
configures the module’s
10/100/1000 Mbps port to Auto-
Negotiate at 10 or 100 Mbps, full or
half duplex mode.
auto1000m This setting is applicable only to the
AT-A46 expansion module. It
configures the module’s
10/100/1000 Mbps port to Auto-
Negotiate at 1000 Mbps only, full or
half duplex mode. This is the default
setting for an AT-A46 module.
The selections 10mfauto, 100mhauto, 100mfauto,
and 1000mfauto Auto-Negotiate to a lower speed
and/or to half duplex mode when required by the
end node.