Allied Telesis AT-S39 - Manual (Page 178)

Chapter 20: Download and Upload Commands
178
UPLOAD
Syntax
upload method=tftp|xmodem type=image|config
Parameters
method Specifies the method of the upload. Options are:
tftp Indicates that the upload will be
performed using TFTP. This
upload method can be used from
either a local or remote
management session.
xmodem Indicates that the upload method
will be Xmodem. This upload
method can be used from a local
management session only.
type Specifies the file to be uploaded. Options are:
image Uploads both the AT-S39 software
image and bootloader.
config Uploads the switch’s
configuration file.
You can specify only one file at a time.
Description
This command uploads the AT-S39 software image and bootloader from
a switch to a management workstation.
This command can also upload a switch’s configuration file to a
management workstation. You might upload a configuration file so that
you can download it onto another switch. This is useful in network
environments where there are AT-8000 Series switches that need to be
configured the same, or nearly the same. You can configure one switch,
upload its configuration file to a management workstation, and then
download it to the other switches, saving you the trouble of having to
configure each switch individually.
You can upload files as follows:
❑ From a local management session