Allied Telesis AT-S39 - Manual (Page 142)

Chapter 15: IGMP Snooping Commands
142
SET IP IGMP
Syntax
set ip igmp [snoopingstatus=enable|disable]
[hoststatus=singlehost|multihost]
[timeout=timeout] [numbermulticastgroups=number]
[routerport=portnumber|auto]
Parameters
snoopingstatus Activates and deactivates IGMP snooping
on the switch. Possible settings are:
enable Activates IGMP snooping.
disable Deactivates IGMP snooping.
This is the default setting
hoststatus Specifies the IGMP host node topology.
Options are:
singlehost Activates the Single-Host/Port
setting, which is appropriate
when there is only one host
node connected to a port on
the switch. This is the default
setting.
multihost Activates the Multi-Host
setting, which is appropriate if
there is more than one host
node connected to a switch
port.
timeout Specifies the time period in seconds used
by the switch in determining inactive host
nodes. An inactive host node is a node that
has not sent an IGMP reports during the
specified time interval. The range is 1 to
86,400 seconds (24 hours). The default is
260 seconds.
numbermulticastgroups Specifies the maximum number of
multicast addresses the switch will learn.
This parameter is useful with networks that
contain a large number of multicast
groups. You can use the parameter to
prevent the switch’s MAC address table