Allied Telesis AT-S39 - Manual (Page 39)

AT-S39 Command Line Interface User’s Guide
39
SHOW DHCPBOOTP
Syntax
show dhcpbootp
Parameters
None.
Description
This command displays the status of the DHCP and BOOTP client
software on the switch. The client software will be either “enabled” or
“disabled.” When enabled, the switch obtains its IP configuration
information from a DHCP or BOOTP server on the network. The default
setting is disabled.
To enable the client software, refer to the ENABLE DHCPBOOTP
command. To disable it, refer to the DISABLE DHCPBOOTP command.
Example
The following command displays the status of the DHCP and BOOTP
client software:
show dhcpbootp