Allied Telesis AT-S39 - Manual (Page 36)

Chapter 3: Basic Switch Commands
36
SET IP ROUTE
Syntax
set ip route ipaddress=ipaddress
Parameter
ipaddress Specifies the IP address of the default gateway for
the switch. The default value is 0.0.0.0.
Description
This command specifies the IP address of the default gateway for the
switch. This address is required if you will be managing the unit from a
remote management station that is separated from the switch by a
router.
To view the switch’s current default gateway address settings, refer to
the SHOW IP command. To return the parameter to its default value,
refer to the PURGE IP command or the RESET IP command.
Example
The following command sets the default gateway address to
140.35.22.12:
set ip route ipaddress=140.35.22.12