Allied Telesis AT-S39 - Manual (Page 177)

AT-S39 Command Line Interface User’s Guide
177
After entering this command, you must specify the location of the
AT-S39 configuration file stored on your workstation using your terminal
emulation program.
TFTP Examples
The following command downloads the AT-S39 image file using TFTP:
load method=tftp type=image
You are prompted for the IP address of the TFTP server and the name of
the image file to download.
The following command downloads a configuration file:
load method=tftp type=config
Again, you are prompted for the IP address of the TFTP server and the
name of the file to download.
Switch-to-switch Examples
The following command downloads the AT-S39 image file on the master
switch to switches 1 and 4 in an enhanced stack. (Switch numbers are
displayed using the SHOW REMOTELIST command.)
load method=remoteswitch type=image
switchnumber=1,4
The following command downloads the AT-S39 configuration file on the
master switch to switch 2 in an enhanced stack.
load method=remoteswitch type=config
switchnumber=2