Allied Telesis AT-S39 - Manual (Page 47)

AT-S39 Command Line Interface User’s Guide
47
SET SWITCH STACKMODE
Syntax
set switch stackmode=master|slave|unavailable
Parameter
stackmode Specifies the enhanced stacking mode of the switch.
Possible settings are:
master Specifies the switch’s stacking
mode as master. A master switch
must be assigned an IP address and
subnet mask.
slave Specifies the switch’s stacking
mode as slave. A slave does not
need an IP address. This is the
default setting for a switch.
unavailable Specifies the switch’s stacking
mode as unavailable. A switch with
this status cannot be managed from
an enhanced stack. It can be
managed locally through its RS232
Terminal Port or remotely if it is
assigned an IP address and subnet
mask.
Description
This command sets a switch’s enhanced stacking status. To view a
switch’s current stacking status, refer to the SHOW SWITCH command.
Note
You cannot change the stacking status of a switch accessed through
enhanced stacking. If a switch does not have an IP address or subnet
mask, such as a slave switch, you must use a local management
session to set the stacking status. If the switch has an IP address and
subnet mask, such as a master switch, you can use either a local or a
Telnet management session.
Example
The following command sets the switch’s stacking status to master:
set switch stackmode=master