Enable portaccess – Allied Telesis AT-S39 User Manual

Page 162

Text mode
Original mode

Chapter 18: 802.1x Port-based Access Control Commands

162

ENABLE PORTACCESS

Syntax

enable portaccess

Parameters

None.

Description

Use this command to enable 802.1x port-based access control on your
switch. When enabled, supplicant nodes must log on to pass traffic
through the switch.

Note

You should configure the RADIUS client software on the switch
before enabling port-based access control. Refer to SET
AUTHENTICATION on page 157.

Note

This command must be performed from a local management
session.

Example

The following command enables 802.1x port-based access control on
the switch:

enable portaccess