Set switch vlanmode – Allied Telesis AT-S39 User Manual

Page 131

Text mode
Original mode

AT-S39 Command Line Interface User’s Guide

131

SET SWITCH VLANMODE

Syntax

set switch vlanmode=userconfig|multiple|
dotqmultiple

Parameters

vlanmode

Specifies the switch’s VLAN mode. Options are:

USERCONFIG

Sets the switch to support port-
based and tagged VLANs. This is the
default.

MULTIPLE Configures

the switch for the non-

801.Q compliant multiple VLANs
mode.

DOTQMULTIPLE Configures the switch for the 801.Q

compliant multiple VLANs mode.
The default is USERCONFIG.

Description

This command configures the switch’s VLAN Mode. The mode can be
user-configured, which supports port-based and tagged VLANs, or one
of two multiple VLAN modes.

Note

The switch can only support these VLAN modes when its mode is set
to tagged. To set the switch mode, refer to the SET SWITCH
SWITCHMODE command.

Example

The following command configures the switch to support 801.Q
compliant VLAN mode:

set switch vlanmode=dotqmultiple