Viewing optical transceivers – Allied Telesis AT-S94 User Manual
Page 213
System Utilities
Page 213
Viewing Optical Transceivers
The Optical Transceivers Page allows network managers to perform tests on Fiber Optic cables. Optical
transceiver diagnostics can be performed only when the link is present.
To view transceiver diagnostics:
1.
Click Utilities > Optical Transceivers. The Optical Transceivers Page opens:
Figure 148:Optical Transceivers Page
The Optical Transceivers Page contains the following fields:
•
Unit No. — Indicates the stacking member for which the interface configuration information is displayed.
•
Port — Displays the IP address of the port on which the cable is tested.
•
Temperature (Celsius)— Displays the temperature (
o
C) at which the cable is operating.
•
Voltage (Volts)— Displays the voltage at which the cable is operating.
•
Current (mA) — Displays the current at which the cable is operating.
•
Output Power (Watts) — Indicates the rate at which the output power is transmitted.
•
Input Power (Watts) — Indicates the rate at which the input power is transmitted.
•
Transmitter Fault — Indicates if a fault occurred during transmission.
•
Loss of Signal — Indicates if a signal loss occurred in the cable.
•
Data Ready — Indicates the transceiver has achieved power up and data is ready.